Roll Forming Machine embedded parts should be accurate and solid, basic to meet the design requirements, and to allow the installation to achieve strength. Factory QTJ4-25 block making machine according to the relevant provisions have been made in the factory are factory test, but because of long-distance transport and long-time placement and other reasons, the installation should be carried out the following checks:
1 Check the machine during transport if there is damage or deformation;
Two main parts of the machine checks whether there is loosening fasteners;
3 Check the gearbox, the exciter vibration table sump lubrication points are required each refueling, fuel is appropriate;
4 Check the main transmission and brake motor braking effect is sensitive and reliable.
Also wipe the machine fully working, roll forming machine even before the test machine and moving parts on the site according to the provisions relative sliding lubrication. If the machine apart due to transportation needs can be divided into forming device, plus base unit, charging device, roller sets and electrical control box and other parts, roll forming machine installation, assembly according to assembly relationships in place.
没有评论:
发表评论